The G2X is a compact, but robust data logger that benefits from Racepak’s 20 + years of motorsports data system design and construction. Many features of our professional data systems were incorporated into the G2X, providing an accurate, dependable and easy to use data logger.
| Weight: |
| |
Logger only - 13oz
Entire G2X kit: 1lb 13oz (.81 kilo)
|
| Memory: |
| |
128MB SD Memory Card
Approximately 25 hours of data (with no external sensors in use)
|
| Automated Logging Process: |
| |
- Logging starts at 25 MPH (40 KPH) which may be changed by user
- Logging stops when no speed is detected for 30 seconds or greater
- Auto-writes consecutively numbered runfiles. Does not overwrite existing data
- Allows user to make multiple runs without downloading data
|
| Internal Sensors: |
| |
- 100Hz Lateral and Longitudinal Accelerometers with -5 / +5 G capability
- 4 Hz GPS board combines with 100Hz accelerometer data for mapping data
- Battery Voltage
- Engine RPM (with appropriate tach signal) |
| Power: |
| |
12-18VDC / 800-900Ma |
| Sensor Inputs: |
| |
12 total external Vnet sensors or gauges connect to the Vnet Port
Vnet sensors may be analog, RPM, event, temperature
RPM A Input
RPM B Input
GPS Antenna Input
|
Engine RPM Signal requirement: |
| |
50% duty cycle, square wave tach output signal (aftermarket ignition box type)
If this type of signal is not available, utilize the Racepak GMR pickup
|
Exterior LED Displays: |
| |
PWR/Card LED
GPS Status LED
|
| GPS Antenna and Cable: |
| |
1” (25mm) x 1” (25mm) Size
Magnetic Base
SMA Connector
|
| |
|
All Racepak products carry a six month warranty |
