Note: The thread size of all G2X Sensors is 1/8 NPT

G2X Sensor Information G2X Sensors Before reviewing our sensor installation information, keep in mind the purpose of using the Vnet (Canbus) method of attaching sensors to the G2X 1. Can I install my own sensor? Yes, the Vnet (Canbus) allows the user to connect their own 0-5V or 0-12V input to the G2X. This is accomplished by use of a generic 0-5V or 0-12V Racepak module, which costs $99.00 each. 2. Why not route individual wires to each sensor? Our method uses a single cable to route the data from all sensors, back to the G2X, resulting in a much cleaner installation. 3. What does this mean to the user? Less weight: Since all the sensors share the same cable, it requires less total wiring to complete the installation Smart sensors: The Vnet (Canbus) allows Racepak to create sensors that "know" what they are, eliminating calibration and setup procedures. Easier to install: Routing one cable throughout the vehicle is much easier than dragging rolls of wire throughout the vehicle. Cost: When reviewing the cost of our Vnet sensors, remember the high quality of sensors untilized by Racepak affects the final cost.

Attaching Customer Supplied Sensors To The G2X
There has always been some confusion on both the cost and ability to add customer supplied sensors to the G2X. The answer is of course you can. If you have a 0-5V or 0-12V powered sensor that returns a 0-5V signal to the data logger, all you will need is either our 0-5 Vnet module (PN: 230-VM-AN-5 / $119.00) or a 0-12V Vnet module (PN: 230-VM-AN-12 / $119.00). Each sensor requires a module. We also offer Vnet modules for Type K thermocouples but always recommend using our thermocouples, as they are specifically spec'd and manufactured for Racepak motor sports usage.